Deli SanDwich ToaSTer (DST-200)
12
P/N 1011001 Rev. B 03/09
trOUblesHOOtInG
problem
possible cause
corrective action
No Display and/or no light on the
Power switch.
unit not plugged in.
Plug the power cord into the
appropriate outlet.
Hi-Limit thermostat is tripped.
Reset Hi-Limit on rear of the unit.
circuit Breaker tripped
Reset circuit Breaker.
Power cord and/or plug are dam-
aged.
contact your maintenance person or
authorized service agency.
inoperable Power switch.
unit displays one of the following
messages:
Upper IR Heater Fault
or
Lower IR Heater Fault
failed heater.
allow about 10 minutes for the
toaster to self adjust.
Wire disconnected in iR circuit.
control wires to the solid state
Relay are disconnected.
adjust the toast quality setting. Refer
to the Operation section of this
manual.
the solid state Relay has failed.
Retainer Ring not locked on plug.
Plug power cord in tightly and lock
the Retainer Ring.
unit displays the following message:
Conveyor Motor Fault
Product is getting stuck in the
conveyor system or the conveyor
system is jammed.
check and clear the vertical and
horizontal conveyors for any stuck
product. Refer to the Operation and
Maintenance sections of this manual
for proper compression settings and
cleaning procedures.
the motor controller circuit has
failed or is inoperable.
call your authorized service agency
for service.
unit displays the following message:
SSR Failure - System Stopped
a relay has failed preventing proper
heater control.
the toaster cannot be operated with
this kind of failure. contact your
authorized service agency for
service.
caUtIOn
to avoid possible personal injury and/or damage to the unit, all inspections, tests, and repair of electrical
equipment should be performed by QUalIfIeD serVIce persOnnel. the unit mUst be shut down and
UnplUGGeD before servicing, except when electrical tests are required. Use extreme care during electrical
circuit tests. live circuits will be exposed.
