DIGITAL HD TV ANTENNA INSTALLATION GUIDE
Antenna mast clamp which holds the antenna to the
mast has been pre-installed on the antenna. Clamp
includes two v blocks, one u-bolt, two washers and
two nuts.
Follow below steps to mount your antenna:
1.
Loosen the nuts and washers attached to the
v-block and pull the u-bolt connected to the v-block
outwards to provide enough space for the antenna
mast to be placed in between.
2.
Mount the antenna mast in between the u-bolt
and the v-block. Slide the antenna over the mast,
(See Figure 3c), direct antenna towards the
transmitter and use a spanner to tighten the nuts.
Use cable ties or tape to secure the coaxial cable
to the antenna mast
(See Figure 3d).
See
“STAGE 4. CABLING ANTENNA”
to know more
about coaxial cable connection.
Note: To get best performance from the antenna,
mount it outdoors, up high, clear from any
obstructions and aligned with the transmitter.
5
To Transmitter
Drip Loop
Coaxial Cable
Cable Tie
or Tape
Fig.3d
U-Bolt
Washers
& Nuts
Mast
V-Block
Fig.3c
