Step 3
(requires an electric drill and
1
/
8
” drill bit)
Determine the location of your drawer unit on your
assembled workstation. Locate the Drill Template. Follow
its instructions to drill the holes for installing your drawer’s
housing assembly.
Once the holes have been drilled and the four wood screws
are partially installed, align the housing assembly with the
workstation so it opens to the front of the workstation and
the four keyholes on the assembly line up with the wood
screws. Slip the housing assembly over the wood screws
(Figure 1), then slide the housing to the back of the
workstation so the screws rest in the narrow end of the
keyholes on the housing (Figure 2). Tighten the wood screws
(Figure 3).
Install the remaining two wood screws into the center holes.
Step 4
Carefully, rotate your workstation so it’s right side up.
Reinstall the drawers to the housing assembly by aligning
the drawer glides
(located on the drawers)
with the drawer
mounts
(located on the housing assembly)
. Then firmly push
the drawers all the way to the rear of your Cart.
Congratulations!
Your drawer assembly is complete.
Items shown shaded are not included with this Accessory.
Figure 1
Insert Wood Screw
through Keyholes.
Figure 2
Push housing to the
back of the workstation
Figure 3
Fully tighten the
Wood Screws.
Keyholes
Firmly push the drawers towards the
rear of your cart.
Drawer
Glide
Center
Holes
Housing
Assembly
3
/
4
” Wood Screw
325-5106-00
Questions? 1-800-325-3841
For warranty information, please visit:
http://www.anthro.com/support/warranty
