Anthem Statement D2v, Руководство по эксплуатации

Страница: 83 / 102

75
5. REMOTE CONTROL CUSTOMIZATION
5.1 CODES FOR OTHER BRANDS
The processor remote can control other components – brands and setup instructions are in Appendix B. If the
brand for your component is not listed, try searching for a code:
1. Turn on the component, for example the DVD player.
2. Press a control mode key other than MAIN, Z2, or Z3, for example DVD .
3. Press and hold LEARN until the light (control mode key) flashes twice then press 9 , 9 , 1 .
4. Press 0 for cable converters, satellite receivers, or video accessories, 1 for TVs, 2 for DVD players
or VCRs, or 3 for CD players or audio amps/tuners.
5. Aim the remote towards the player and press POWER (or Play). If the player does not respond, press
CH+ to try the next code. If the player responds, press LEARN to lock the code. Codes are sent in
order of popularity. CH goes to the previous code. If no code is found, see section 5.2.
6. After finding a code, record it: Press and hold LEARN until the light flashes twice, then press 9 , 9 , 0 , 1 .
Wait 3 seconds and count the number times that the light flashes. This represents the first digit (for
example, 3 flashes = 3, no flash = 0) – write this down. Next, press
2 for the second digit, 3 for the
third digit, 4 for the fourth digit, 5 for the fifth digit and write the number of flashes each time.
5.2 LEARNING COMMANDS
Commands from other infra-red remote controls can be captured by the processor remote control. The
factory command is still available by pressing LEARN before pressing the taught key.
If the factory command is used more than the learned command, the learned command can be programmed
in Layer2 instead. In this case, the learned command is sent by pressing LEARN before pressing the key.
Before teaching a key note the following:
• Control mode keys and LEARN can not be taught. These keys never send IR commands.
• A multiple key sequence (for example Rec+Pause or Rec+Play) can not be taught to one key.
• A high level of ambient light, light from displays, and exposed fans could interfere with learning.
To teach a key:
1. Point the source and processor remotes at each other, holding them 2 inches apart.
2. Press and hold LEARN until the light flashes twice then press 9 , 7 , 5 . One long blink indicates low
battery or faulty memory – the remote will not go into learn mode under these conditions.
3. Press the desired control mode key.
4. Press the key to be taught , or to program the command into Layer2 press LEARN (don’t hold) then
press the key to be taught .
5. The light flashes rapidly. Within 4 seconds, press and hold the teaching key on the source remote
until the light flashes twice. One long blink means bad capture (try again), memory full (delete
another command), or unlearnable code.
6. Repeat steps 3-5 or 4-5 as often as desired until memory is full.
7. To exit, press and hold LEARN until the light flashes twice or wait 10 seconds.
Deleting learned commands:
1. Press and hold LEARN until the light flashes twice, then press 9 , 7 , 6 .
2. To delete a learned command from one key, press the control mode key, then the key to be deleted
twice. To delete all learned commands in the control mode, press the control mode key twice.