Command
Name
26
Volume Down
27
Mute Toggle
28
Last
29
Tone
30
Bass
31
Treble
32
Lip Sync
33
Balance
34
Dynamics
35
Clear
36
Preset
Z2IRCommand
[analog]
The Zone2 IR Command is used to simulate an existing IR command sent to the zone 2. Some commands are
only accessible this way, like the OSD direction commands. The available commands are available in the table
listed in the IRCommand join above.
String Inputs
Rx$[255]
[string]
The Rx$ join is used to connect to the TCP/IP client, or the RS-232 connection in your project. Please refer
to the section labeled Module Configuration for details on how to configure the connection to the receiver.
CustomMessage[3]
[string]
The Custom Message joins (1 to 3) are used to send a custom message to the display on the Receiver. There
are three lines available that correspond to the three joins, CustomMessage[1] for line 1, etc. The maximum
length for each line is 32, any additional text will be clipped. To display the message the MessageDisplay join
must be held high.
Page 16
