3
1
2
7
4
6
6
3
3
5
5
8
8
SET UP THE ANTENNA:
To TV
(sold separately)
To LEFT Element
(1)
.
To RIGHT Element
(1)
.
Use the Large Zip Ties
(9)
to secure the Coaxial Cables
(8)
to the
Bowtie Elements.
Use the Large Zip Ties
(9)
to secure the
Coaxial Cables.
Smal l
Zip Ties
(9)
DO NOT TIGHTEN.
This allows
the Reflector Panels
(2)
to
turn in desired direction.
Coaxial Cable and Mast (sold separately).
Go to antennasdirect.com
Required:
Coaxial Cable
(sold separately)
, Adjustable Wrench, Power Drill, 3/16” Drill Bit, 8 and 10mm Ratcheting Drivers, and a #2 Phillips Screwdriver.
Attach the Bowtie Elements
(1)
to the
Reflector Panels
(2)
with
the 5½” Bolts, Aluminum Sleeves,
and Hardware
(3)
.
With arrows pointing upward
on the Swing Bracket
(5)
, attach to
each Reflector Panel
(1)
using
the Swing Bracket Hardware
(5)
.
Tighten the hardware.
Attach the Mast Mounting Hardware
(6)
and the Combiner
(7)
to the Crossbar
(4)
as shown.
With all coaxial cable connections pointing downward
on the Combiner
(7)
attach one panel at a time to the
Crossbar
(4)
using the Flange Nuts
(5).
Adjust the
Reflector Panels
(2)
so they are parallel to the CrossBar
(4)
.
Tighten the hardware
(5)
.
Route the left and right Coaxial Cables
(8)
through each
Reflector Panel
(2)
and connect the Coaxial Cables
(8)
to the
connector on the Bowtie Elements
(1)
and slide the Weather Boot
over each connection.
Connect each Coaxial Cable
(8)
to the Combiner
(7)
using the ends
without
the Weather Boot.
Now that you’ve installed your antenna, you are ready to scan for channels. See
“Scanning for channels”
in the troubleshooting guide.
Congratulations! You’re watching HDTV for FREE! Welcome to the Antennas Direct cord-cutting family.
TV or Converter Box
USB Port
Antenna Input
USB
ANT-IN
HDMI
CVBS
L
R
Y
Pb
Pr
USB Port
Antenna Input
Mast and Coaxial Cable (sold separately)
REAR VIEW ON MAST
FRONT VIEW
Make sure the front of
the antenna is facing the
broadcast towers.
Before installing the antenna on a mast, adjust the mast, so it is in a
vertical position.
You will need to adjust the antenna after it is mounted
for the best reception.
Slide the antenna’s mounting hardware through the Mast Clamps
(6)
and tighten the Wing Nuts
(6)
.
To aim each panel in different directions, loosen the Flange Nuts
(5)
on
the Swing Brackets
(5)
. Turn each panel in the desired direction and
then tighten the Flange Nuts
(5)
. Perform a channel scan.
IMPORTANT: CHECK THE RECEPTION IN THE LOCATION WHERE YOU
INTEND TO INSTALL THE ANTENNA PRIOR TO ATTACHING THE MAST
TO ANY SURFACE.