noisy at source in which case you can try lower VIDEO FILTER settings, which affect
picture sharpness.
Under NAMES, choose and enter the displayed CHANNEL NAME for each video input
(AV1, AV2) and if required the common NETWORK NAME.
Under SERVICE, only edit the LCN as described above, for each AV input. (Just to re-cap,
these are the channel numbers as shown on a DVB TV).
Under NETWORK make sure this is not the same as any broadcast networks.
STATUS is an engineering readout of system performance and can be ignored.
3.3.
LED Indicators
RED LED
Power ON
GREEN LED
STATUS OK (encoder running)
YELLOW LED
RF ON
(Table 5) LED Indicators
4.
Configuration
This section defines the various settings that can be changed within the modulator either
from the on-board LCD display & keypad or via the RS232 interface.
4.1.
General
General unit settings
4.1.1. Time
Allows the setting of the DTX1 on-board Real Time Clock.
4.1.2. Date
Allows the setting of the DTX1 on-board RTC
4.1.3. LCD Contrast
This parameter sets the bias voltage, in order to control the contrast of the on-board LCD
Display.
4.2.
Input
(AV Input 1 & AV input 2 [if fitted]) This parameter specifies the characteristics of the video
input signal.
BATC DTX1 (Iss 1.1)
Copyright 2013 Antennair Ltd
15
