Antelope Orion32+, Руководство пользователя

Страница: 22 / 28

20
11. Technical Specifications
Inputs:
Analog: 4 x D-SUB 25 (32 channels), +20 dBu max, 11.2 kOhms
Digital: 1 x Fiber Optic MADI
2 x ADAT
1 x S/PDIF
Word Clock: 1 x Input @ 75 Ohms 3Vpp on BNC 32 – 192kHz
Atomic Clock: 1 x 10M Input @ 75 Ohms 1Vpp on BNC
Outputs:
Analog: 4 x D-SUB 25 (32 channels), +20dBu, 56 Ohms
2 x Monitor Outs on TRS ¼ Jacks
Digital: 1 x Fiber Optic MADI
2 x ADAT
1 x S/PDIF
Word Clock: 2 x Outputs @ 75 Ohms 3Vpp on BNC 32 - 192kHz
USB I/O:
USB 2.0 Hi-Speed; Data stream up to 480 Mbits/192kHz,
32 channels I/O, Type B
Thunderbolt
TM
: 1 x Thunderbolt
TM
● Check what clocking mode you are in. Are you receiving the clock signal from the source?
● Check that the relevant lock light on the control panel of the is lit up.
● Try a different cable and another source if available.
● Check the routing on the control panel. Have you routed the signal path correctly?
● If you have routed signals to the routing mixer, check their corresponding fader is up.
● Check the relevant peak meters of the control panel by selecting them in the drop down
menu to see if the relevant signal is being received or is being outputted.
DAW
● What buffer size is your DAW set to?
If it is significantly low i.e. lower than 128 samples in your buffer size, try increasing it.
Try increasing the buffer size from the control panel (Windows Only)
Have you checked the input and output routing is correct in your DAW?
● Is the device selected in the relevant sound card section of the DAW’s preferences?
If the doesn’t show up in you DAW, first try unplugging and plugging back the
Thunderbolt
TM
cable (or the USB cable), then restarting your Computer and finally re-
install the firmware, drivers and control panel for the .