Antelope OCX-V, Руководство пользователя

Страница: 7 / 16

5
The DA mode will not work if the SOURCE knob is set to VIDEO or OVEN, as there
is no audio reference to distribute. In this case the red LED above SAMPLE RATE
knob will flash. Note that in the DA mode, the OCX-V can work with non-standart
sample rates as may occur in vari-speed mode; any sample rate from 30 to 202 kHz is
acceptable.
Pull Up / Pull Down Buttons
These buttons are used to modify the outoing sample rate chosen with the Sample
Rate knob. The first button accommodates the United States pull up / pull down
standard, increasing or decreasing the selected sample rate by 0.1%. The second
button accommodates the European pull up / pull down standard, increasing or
decreasing the selected sample rate by 4%.
The rectangular LEDs above each button indicate whether the frequency is pulled up
(+), pulled down (-), or not modified (0) by its corresponding button. You can always
use the Frequency Display window to see the actual frequency the unit outputs, with
the pul ups / pull downs selected at the moment.
Note that pull up / pull down feature is disabled when the Sample Rate switch is set to
DA.
Frequency Display
Displays the sample rate outputted by the Word Clock, AES / EBU and S/PDIF outputs.
Word Clock outputs 7 and 8 are capable of providing fractional frequencies different
from the one displayed here. When the output frequency can not be generated during
some error conditions, the display will show “------”.
Contrast Knob
Adjusts the contrast of the frequency display.
Status LEDs
LOCK, when lit indicates that the OCX-V is locked to a valid incoming reference.
ATOMIC, will be lit if SOURCE is set to OVEN, and incoming atomic clock signal is
present
OVEN, will flash when the OCX-V is first turned on, until the oven reaches its
temperature of operation. Once this temperature is achieved, th light will remain lit.
NTSC / PAL, will be lit if SOURCE is set to VIDEO, and the incoming video signal is
either NTSC or PAL format.
HDTV, will be lit if SOURCE is set to VIDEO, and the incoming video signal is a valid
HDTV format. See Appendix B for a list of the supported HDTV formats.