Operating Manual ECD3AM-00-00
Page 13 of 13
(07/16) R0117AGB
4.Manufacturer’s declaration
The manufacturer, ANTEK GmbH, herewith declares that the drive regulator ECE3AP must
be used as a component of the control equipment for variable speed motors to be installed in
a machine or to be used for the construction of a machine together with other components.
The drive regulators are not machines as defined in the machine guideline 89/392/EWG.
Notes and recommendations for the installation and proper operation are included in this
technical documentation.
The start-up of the machine is prohibited until it has been determined that the protection and
safety requirements of the machine guideline 89/392/EWG including revisions 68/EWG are
fulfilled.
In this technical documentation, the measures are described with which the drive regulator
complies with the EMC-limiting values. The electromagnetic compatibility of the machine is
based on the method and thoroughness of the conducted installation. The User is
responsible for the compliance of the EMC guideline 89/336/EWG including the revisions
92/31/EWG during operation of the machine.
Norms and regulations observed
♦
Installation of high-voltage current plants with electrical operating equipment: DIN VDE
0160
♦
Regulations for the set-up of high-voltage current plants: DIN VDE 0100
♦
IP-protection systems: EN 60529
♦
Basis material for printed circuits: DIN IEC 249 Part 1
♦
Printed circuits, circuits boards: DIN IEC 326 Part 1
♦
Regulation of air and flow routes: DIN VDE 0110 Part 1-2
♦
De-charging of statically electricity (ESD): EN 50082-2
♦
Rapid transient interference factors (Burst): EN 50082-2
♦
Radio shielding of electrical operating equipment and plants: EN 50081-2, EN 55011
