Antec SONATA IV, Руководство пользователя

Страница: 10 / 12

9
3.5 Rewiring Motherboard Header Connectors
If a case connector does not have the same pin-out as the corresponding motherboard header,
it may need to be reconfigured. Examples could be for your USB header, audio input header, or
some other front panel connector such as the Power Button connector.
Before performing any work, please refer to your motherboard manual or your motherboard
manufacturer’s website to be sure of the pin-out needed for your connector. We strongly
recommend making a notated drawing before beginning work so that you can recover if your
work is disturbed.
1. Determine which wires you need to remove in order
to rewire your plug to match the USB pin-outs on
your motherboard (refer to your motherboard manual).
Working on one connector at a time, use a very small
flathead screwdriver or similar tool to lift up on the black
tab located beside the gold posts (squares). This will
allow you to easily slide out the pins from the USB plug.
2. Working carefully so as not to damage the wires,
connectors, or pins, slowly remove the pin from the
connector. Repeat these steps for each wire you need to change.
3. Slowly reinsert the pin into the correct slot of the connector, then snap closed the black
tab that was lifted in step 1. Repeat these steps for each wire you need to change.
Cooling System
4.1 TriCool™ Fan
There is one 120 x 25 mm TriCool™ fan pre-installed at the rear of the case. This fan is installed
so air will be blown out of the case. It has a 3-speed switch that lets you choose between quiet,
performance or maximum cooling. This switch is located at the rear of the case. The default fan
speed setting is low.
Size:
120 x 25 mm TriCool™ fan
Rated Voltage: DC 12V
Operating Voltage: 10.2V – 13.8V