5
Note:
When connecting an additional SATA Connector, we recommend connecting it to the
existing SATA wires (5 wires) so it can incorporate the +3.3V output. This will allow you to
power next-generation SATA devices.
4. With one hand holding the connector, use a flat head screwdriver to push wires into the
proper notch on the connector. (See Picture 7.)
a)
Black Wires are Ground
b)
Yellow Wires are +12V
c)
Red Wires are +5V
d)
Orange Wires are +3.3V
5. Close the cap to complete the installation. (See Picture 8.)
Warning:
1. Please be careful! A connector with incorrectly aligned wires will damage the device
connected to it. It could also damage the power supply, or even your entire system.
a. We STRONGLY recommend that you use a multi-meter to measure the voltage from the
newly added connector to make sure it has been done correctly. (See Picture 9.)
b. If you need to remove an additional connector from a cable, please wrap each individual
wire with electrical tape (see Picture 10).
Disclaimer: The additional connectors are provided for your convenience. Antec will
not be responsible for any damage due to the incorrect connection of the additional
Molex or SATA connectors.
Picture 5
Picture 6
Picture 7
Picture 8
Picture 9
Picture 10
