3.
The side that attaches to devices should be the side that has 2 con-
nectors. This will enable you to connect another device if you wish.
4.
Connect the far end of the cable to your motherboard on the IDE port,
either IDE 1 or IDE 2.
Fan Installation
The KS-288 case has one optional fan that can be installed in the front.
Note: Antec Cooling Fans blow in the direction that the Antec logo is
facing.
1.
Squeeze the sides of the fan cage near the speaker to release pres-
sure on the tabs. Once loose, you should then be able to pull the cage
back and out of the case.
2.
Drop the fan into the cage and push it in until it clips in.
No screws are needed.
3.
Reattach the cage/fan assembly to the case paying attention to the wires
of the fan. There are slots near each corner to put the wires through (any
corner will work, find the one that's best for you).
4
Connect the 4-pin male connector to a 4-pin female connector coming
out from the power supply.
