Antec ISK 310-150, Руководство пользователя

Страница: 8 / 10

7
Pin Signal Names Pin Signal Names
1
USB Power 1 2 USB Power 2
3
Negative Signal 1
4
Negative Signal 2
5
Positive Signal 1 6 Positive Signal 2
7
Ground 1 8 Ground 2
9
Key (No Connection)
10
Empty Pin
Pin
Signal Names
(HDA)
Pin
Signal Names
(AC’97)
1 MIC2 L 1 MIC In
2 AGND 2 GND
3 MIC2 R 3 MIC Power
4 AVCC 4 NC
5 FRO-R 5 Line Out (R)
6 MIC2_JD 6 Line Out (R)
7 F_IO_SEN 7 NC
8 Key (no pin) 8 Key (no pin)
9 FRO-L 9 Line Out (L)
10 LINE2_JD 10 Line Out (L)
C
ONNECTING THE
F
RONT
I/O P
ORTS
3.1 USB 2.0
Connect the front I/O panel USB cable to the USB header pin on your motherboard. Check the
motherboard manual to ensure that it matches the table below:
3.2
E
SATA
You will find a SATA connector on a cable attached to the front ports. This internal SATA connector is
designed to connect to a standard SATA connector on your motherboard. This will allow high-speed
external hard disk enclosures such as the Antec MX-1 to run at the same speeds as internally installed
hard disks.
3.3
AC’97 / HD A
UDIO
P
ORTS
There is an Intel® standard 10-pin AC’97 connector and an Intel® 10-pin HDA (High Definition Audio)
connector linked to the front panel of the case.
10 6 4 2
9 7 5 3 1
You can connect either the AC’97 or the HDA connector, depending on your motherboard. Locate the
internal audio connectors from your motherboard or sound card and connect the corresponding audio
cable. Consult your motherboard or sound card manual for the pin-out positions. Even if your system
supports both standards, only use one connector.
9 10
1 2