Antec ISK 110 VESA, Руководство пользователя

Страница: 6 / 11

5
H
ARDWARE
I
NSTALLATION
G
UIDE
2.1 R
EMOVING THE
L
EFT
P
ANEL
Lay the case on its right side, with the I/O panel facing you.
You will be removing the left panel (the one with the fan)
1. Remove the two screws from the rear of the panel.
2. Using your thumbs, push up on the rear of the panel until the entire
panel pops free from the rest of the chassis.
Note : Do not use your fingernails to pry or lift the
panels.
2.2
M
OTHERBOARD
I
NSTALLATION
1. Lay the case down, with the open side facing up.
2. Make sure you have the correct I/O panel for your motherboard. If
the panel provided with the case isn’t suitable, please contact your
motherboard manufacturer for the correct I/O panel. Install the I/O
panel at the rear of the case.
3. Align your motherboard with the motherboard standoff holes
located at the rear of the case.
4. Screw in your motherboard to the standoffs with the provided
Phillips-head screws.
5. Attach the 24-pin connector of the included cable bundle to the
motherboard and connect the 18-pin connector to the already
installed PCB in the case.
6. Your motherboard is now installed. Refer to section 3.1 for
instructions on how to connect the I/O panel cables.
Remove these case screws
Motherboard screw locations
Pop the panel free