6
Installation
Installing the Hazer
Remove all packing materials from the Hazer. Check that all foam and plastic padding is removed,
especially in the nozzle area.
Fill with Hazer Liquid (ordercode 60626) or other high-quality water-based fog fluid. Any other types of fluid
can damage the unit. Note the maximum fluid level mark located on the rear of the hazer. Pour hazer liquid
into the liquid tank, being careful not to exceed the maximum fluid level. DO NOT OVERFILL.
When filled, place cap back on liquid tank.
Firmly attach the remote control cable to the proper input on the rear of the machine
The unit can only be operated at floor level or sitting on any regular surface.
It is important that the fog does not shoot directly at any one’s face. Therefore, do not point the nozzle in a
direction that will aim directly at a person.
Whatever installation method you choose, do not allow the unit to have more than a 15 degree angle of
inclination.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Procedure :
Your hazer may be operated with (
2
) or without a remote controller (
1
).
1.
Plug power cord into a grounded electrical outlet. If necessary, turn power switch on rear of unit to “ON”
position. Haze emission will begin automatically.
2.
To operate via remote control, press the appropriate button on the remote to begin haze emission and
hold for the desired length of time.
3.
For further information on operating your Antari Fog Machine, see Remote Control Operation.
Remote Control Operation
1 2
3 4 5
Fig. 4
Optional Remotecontrol
:
HCR-1:
Wireless remote controller with
1
/
4
” stereo plug for ANTARI Hazer
models HZ-100 and HZ-400. Attach the receiver’s magnetic base to the hazer. Plug the receiver’s cable
into the hazer’s remote control input. Using the sending unit, your ANTARI Hazer can be operated from a
distance of up to 50 meters. Start haze emission by pressing the small button on the sending unit. Stop
haze emission by pressing the large button. Multiple ANTARI Hazers may be controlled using only one
sending unit.
HC-1
: 10 meter wired multi-function remote controller
1
/
4
” stereo plug for
ANTARI Hazer HZ-400. Its two knobs allow the operator to customize
hazer machine functions by adjusting haze emission duration and
interval.
1.
Adjust the duration of each haze emission (within the range of 1 to 10
seconds) by means of the DURATION control knob
2.
Adjust the interval between each haze emission (within the range of
10 seconds and 5 minutes) by means of the INTERVAL control knob.
3.
Press the yellow TIMERS button to activate the timer function. When
activated the yellow light will turn on.
4.
Press the red CONTINUOUS button for continuous output.
5.
When pressed, the green MANUAL button overrides all other function
controls, and activates maximum output.
Содержание HZ-400
Страница 1: ...Antari HZ 400 ORDERCODE 60662...
Страница 12: ...2009 Antari...
