ANTAIRA STE-516C, Руководство пользователя

Страница: 18 / 68

Device Server User Guide
18
Chapter 4. Installation
This chapter provides information related to connection of this serial device server. The
following is the method to connect this serial device server to device and network.
Before Installation
In order to connect this device server to network, you need RJ45 Ethernet port. Ethernet
supports 10Mbps and 100Mbps connection. (Automatic recognition) Since this device serv
er’s WAN/LAN port supports MDIX, you can use any type of cable. (ex. Cross LAN cable,
Direct LAN cable) One end of the cable is connected to this device server while another is
to Hub switch or other network device.
Booting
First, make sure that an input voltage supplied to the device server is in accordance with
module’s specification. If power supply is in a normal condition, turn on the device server
and check the PWR LED is white then boot it. Even though there is no additional LED to
check module’s operating status, it is possible to check trough LED on RJ45 Ethernet port.
For information related to LED condition, refer to chapter 3.
IP address is needed to get an access to set up this device server web and telnet command
line. In default, a fixed cable IP address is assigned in this device server. It is possible to
assign a different IP address or let this device server automatically get IP address from
DHCP server after the first access. However, it is recommended to use a fixed IP address.
Connection
In order to check the device server’s status and set up the device, it should connect to