Antaira Technologies - Industrial Ethernet Switches
LMP-1802G-M12-10G-SFP-67-110 Series - Hardware Manual - v1.0
3 Mounting Installation
3.1 Wall Mounting
Follow the steps below to mount the industrial Ethernet switch to a wall using the screw holes as shown below in
Figure
3.1
.
Figure 3.1 - The Rear Side of the Switch
Follow the steps below to learn how to hang the industrial Switch.
Step 1. Prepare 4 screws for mounting the switch to a wall.
Note:
Recommended use the M5 screws.
Step 2. Based on the
Figure 2.1: Physical Dimensions
which is shown the positions of 4 screw holes on the left and right
side of the switch to make 4 screw holes on a wall accordingly.
Step 3. Insert the screws through the screw holes on the switch and screw the switch into the wall. Shown above in
Figure
3.1
.
Step 4. To remove the switch from the wall, do the opposite from the steps above.
Note:
Make sure to disconnect all cables from the switch before removing the unit from the wall.
