Antaira Technologies - Industrial PoE Injector
INJ-C200G-bt-T - Hardware Manual - v1.0
4 Hardware Installation
4.1 Installation Steps
This section will explain how to install the industrial PoE injector:
Caution: This device is intended for indoor use.
Attention: Cet appareil est destiné à une utilisation en intérieur.
Caution: The device is intended to be installed in an industrial control enclosure and panel.
Attention: L'appareil est destiné à être installé dans une armoire de commande et un panneau
industriels.
Installation Steps
1. Unpack the industrial PoE injector from the original packing box.
2. Check if the DIN-Rail bracket is screwed on the industrial PoE injector.
●
If the DIN-Rail is not screwed on the industrial PoE injector, please refer to the DIN-Rail
Mounting section for DIN-Rail installation.
●
If it is required to wall mount the industrial PoE injector, please refer to the Wall Mounting
section for wall mounting installation.
3. To hang the industrial PoE injector on a DIN-Rail or wall, please refer to the Mounting Installation
section.
4. Power on the industrial PoE injector and then the power LED light will turn on.
●
For the help on how to wire power, please refer to the Wiring the Power Inputs section.
●
Please refer to the LED Indicators section for LED light indication.
5. Prepare the twisted-pair, straight-through category 5 cable for Ethernet connection.
6. Insert one side of the RJ45 cable into the injector’s Ethernet port and on the other side into the
networking device’s Ethernet port, e.g. switch PC or server.
12
