Programming
How to Enter Program Change
74
IQ-301 PN 50036:F 10/29/2001
Create a New Program for the Control Panel
This section covers how to use the Autoprogram option to create a new program for the
control panel. The control panel will identify all addressable detectors and modules
connected to the SLC then display default program information for each installed
device.
Note: If your system includes a relay module, you must manually set this from
“control” to “relay” after completing autoprogram. Refer to “How to a Program a
Control or Relay Module” on page 83 for details.
To create a new program for the control panel, follow these steps:
1. Use the Clear option to clear program information from memory. For instructions
on doing this, refer to “How to Clear a Program from Memory (0=clr)” on page 73.
2. From the Program Change screen, press the
1
key to start Autoprogram. The
control panel scans the system to identify all detectors and modules connected to
the SLC and displays the following screen:
Figure 56 Autoprogram Prompt
3. When finished identifying SLC devices, the LCD displays the first detector or
module in the following order: detectors in address order (D01, D02, and so on),
monitor modules in address order, and control or relay modules in address order.
For example, Figure 57 shows a sample screen for a new device identified by the
control program during autoprogram.
Figure 57 Sample New Device Screen
Program Change
Password
AUTOPROGRAM
PLEASE@WAIT
PROGRM@SMOKE(PHOTO)
DETECTOR@ADDRESS@01
ZO3@Z@@@Z@@@Z@@@Z@@
2.0%@@@@@@*P*@@@@D01
Default Autoprogram information for the device.
To edit this information, refer to “How to Edit or
Delete a Point (2=point)” on page 78 for
instructions.
Device address
(detector at SLC
address 01 shown)
Type Code for the device which you can only edit
using the Point Programming option. For details,
refer to “How to Edit or Delete a Point (2=point)”
on page 78.
Default label for the device. To edit,
refer to “How to Edit or Delete a Point
(2=point)” on page 78.
Содержание AUTOPULSE IQ-301
Страница 195: ...IQ 301 PN 50036 F 10 29 2001 195...