ANSMANN 1800-0025, Руководство пользователя, Страница: 10 / 92

teChniCal data (wireleSS teChnology)
Transmission technology: DECT with automatic radiation-stop-function HEAlTH DECT
Frequency Range: 1880 - 1900MHz
Channels: 120
Channel Selection: Automatic
Maximum output power: <250mW
Average transmission power: <10mW
trouBleShooting
If problems occur, please read the following checklist. Check to see if the baby and/or the parent units are turned on. Check if the parent is plugged in to the power supply unit and if the batteries are in place.
the operating indiCator led on the BaBy or parent unit iS turned oFF:
there iS no Sound CoMing FroM the SpeaKerS oF the parent unit:
tranSMiSSion interFerenCe:
CauSe Solution
The baby or parent power is off. Turn on the baby or parent unit as appropriate.
The batteries are discharged in the parent unit. Recharge or replace the batteries.
The power supply of the affected device is unplugged or not correctly connected. Check all connections.
There is no electricity available. Check that the electrical outlet delivers power.
CauSe Solution
No sound is played back, the parent device is turned on and the HEAlTH DECT mode is activated.
Please move for a short time the Health DECT mode slide switch to PERMANENT. A manual range check
is performed. It may be that the baby unit out of range or is turned off.
The HEAlTH DECT mode (sound activation) was selected.
Make a loud noise near the baby unit to check sound transmission. Once a louder sound is heard, the
baby unit is reactivated.
The volume on the parent unit is set too low. Turn up the volume on the parent unit until you can hear your signal.
The batteries are discharged in the parent unit. Recharge or replace the batteries.
The parent unit is off. Turn the parent unit on.
CauSe Solution
In rare cases, interference due to the presence of a similar transmitting device in the immediate
vicinity may occur.
Place the parents and / or baby units to a more suitable location.
This can include power lines or electronic equipment.