29
1.
Grip the tab on the filter
and pull down and then
outwards.
2.
Clean the filter with hot
soapy water. Rinse and
allow to dry before fitting.
Do not put the filter in a
dishwasher.
3.
Insert the top edge of the
filter
first,
and
then
carefully press in.
NOTE:
Never use the appliance without a filter
– dust and impurities will reduce the performance of the
appliance.
Cleaning the water container
Clean the water container every two or four weeks to prevent the build-up of mildew and bacteria
etc.
Pour a little fresh water with mild detergent into the water container, swish round, pour out and
rinse.
NOTE:
Do not wash the water container in a dishwasher. Check after cleaning that the water container is
properly inserted, otherwise the appliance will not work.
Cleaning the air filter
Check and clean the air filter, located inside the front grille, at least once a month.
NOTE:
Do not wash the filter in water, or in a dishwasher.
Storage
1.
Switch off the appliance, and empty the water tank after one day.
2.
Clean the appliance, the water container and the air filter.
3.
Wind up the power cord on the holder.
4.
Cover the appliance with a plastic bag.
5.
Store the appliance upright in a dry, well-ventilated area.
TROUBLESHOOTING
Check the following points before contacting your dealer for a service.
Problem
Cause
The appliance will not start.
The power cord is not properly plugged into the mains
socket.
The fuse has tripped.
The set target humidity has been reached, or the water
container is full.
The water container is not properly inserted.
The air is not dehumidifying properly.
The appliance has not been working long enough.
The air flow to the appliance is blocked by furniture or
curtains, etc.
The target humidity is set too high.
Doors, windows etc. have not been closed.
The room temperature is too low (lower than 5°C).
Something in the room is emitting moisture.
The appliance is noisy.
The air filter is blocked.
The appliance is tilted.
The surface is not horizontal.
Frost on the evaporator coils.
This is quite normal. The appliance defrosts automatically.
Water on the floor.
Leakage from the hose or connection.
A hose has not been connected, and the rubber plug has
not been inserted.
E1, E2, P1 or P2 are shown on the
display.
These error and warning codes are described in the
control panel section.