Anslut 012958, Руководство по эксплуатации

Страница: 52 / 56

EN
52
HOW TO USE
FAN ADJUSTMENT
The fan is adjusted at the factory and ready
to use. It does not normally need adjusting.
Follow the instructions under RESET OF
FACTORY SETTINGS if want change the fan
settings. The factory settings can be reset at
any time.
Factory settings
Air flow in SLEEP mode 0 m³/h
Air flow in 24 HOURS mode (Ø 125/Ø 100)
40/33 m³/h
Air flow in QUIET mode (Ø 125/Ø 100)
83/72 m³/h
Air flow in MAXIMAL mode (Ø 125/Ø 100)
97/82 m³/h
Dehumidification mode MAXIMAL
Delayed start 0 min
Stop delay 5 min
Humidity timer 30 min
24 HOURS Deactivated
CONTROL PANEL
A. Adjusting dehumidification mode.
B. Adjusting the start/stop delay.
C. Adjusting the speed for
QUIET and
MAXIMAL mode.
D. Adjusting delayed start.
E. Activation/deactivation of
24 HOURS
mode.
F. The button does not function on this
model.
FIG. 9
REMOTE CONTROL
The fan emits an audio prompt when it
receives a signal from the remote control. If
no audio prompt is heard, press the required
button again. Move the remote control closer
to the fan, if necessary.
NOTE:
The maximum range is about 3 metres. Point
the remote control straight at the fan for best
functionality.
On/Off
Selection of
dehumidification mode
and adjusting the speed
for
QUIET mode.
Selection of mode for
maximal dehumidification
and adjusting the speed
for
MAXIMAL mode
Does not function on this
model.
Activation/deactivation of
pause mode.
Activation/deactivation of
24 HOURS mode.
Adjusting the start delay
(0, 2 or 5 minutes).
Adjusting the stop delay
(5, 15 or 30 minutes).
NOTE:
The buttons TEMPERATURE SE/- and
ON/OFF MOVE do not function on this model.
FAN MODE STATUS
External switch activated
– Green LED constant.