Anslut 012538, Руководство по эксплуатации

Страница: 20 / 23

EN
20
WARNING!
• Some parts of the product get very hot
– risk of burn injuries. Keep the product
under careful supervision when it is used
by, or near children or persons with
functional disorders.
• Do not put any foreign objects on the
product.
• Never poke your fingers or any other
objects into the inlet or outlet openings.
• Do not use the product near a bath,
shower or swimming pool.
• Do not cover the product, this can result
in overheating.
SYMBOLS
Read the instructions.
Do not cover.
Approved in accordance with
the relevant directives.
Recycle discarded product
in accordance with local
regulations.
TECHNICAL DATA
Rated voltage 230 V ~ 50 Hz
Output 2000 W
Power settings
25/1000/2000 W
Overheating protection 65°C
Safety class I
Protection rating IP20
Size 21 x 16 x 21.7 cm
Weight 1.7 kg
DESCRIPTION
1. Status light
2. Thermostat dial
3. Mode selector
4. Fan mode
5. Low output mode + fan
6. High output mode + fan
FIG. 1
USE
BEFORE USE
1. Unpack the product and all the parts from
the packaging and place them on a level
surface.
2. Check that the mains voltage corresponds
to the rated voltage on the type plate.
Plug in the plug. The product is now ready
to use.
IMPORTANT:
• Do not place the product near walls or
corners, where incoming or outgoing air
can be blocked.
• Do not place the product directly below
a power outlet.
HOW TO USE
1. Place the product standing upright on
a level, stable surface at a safe distance
from flammable objects and substances.
2. Plug the plug into the power point.
3. Set the thermostat dial to the required
mode.
4. Start the product by setting the mode
selector to the required output.
5. The heater element switches off when the
set room temperature is reached, but the
fan continues to run. The heater element
starts again when the temperature