if the main set received the alarm signals from detectors, it will alarm if set no delay time,but
if you set a delay time for guard,for example 30 seconds, setting guard will take into effect
only after 30 seconds later from the time you pressed the
key. This delay time can be
normally left for you to prepare to exit your house entry.
Fig.2 Setting panel illustration
Fig.3 Remote controller illustration
*withdraw guard setting by remote controller:
Press and release
key on the remote controller, the “GUARD”LED on the main set
will go out ,the main set went into status of withdraw guard. At this time, if the main set
received the alarm signals from all detectors of zone 1,2,3,4, it will not alarm.
2.
setting guard by pressing keypad on the main set
*Setting guard on the keypad:
When not in alarm state,press four digits user password consecutively (for example: “1234”,
ect),then press key “set” ,then press digit “ 9”, the “GUARD” LED on the main set will light
up ,the main set went into status of setting guard. At this time if the main set received the
alarm signals from detectors, it will alarm at once or delayed for a period of option
time(0~90s),
* withdraw guard on the keypad
Press four digits user password consecutively, then press key set,then press digit 0, the main
set went into withdraw guard, in this state, if the main set received the alarm intruder signal
from the detectors , it will not alarm , but if it received trigger signal from the panic button of
the remote controller, it will alarm and dial out telephone numbers automatically.
3.
Open or close a guard zone alarm
Each of the four guard zone can be opened or closed, if a guard zone is closed, the main
set will not report out alarm signal from the guard zone received.For example ,if a PIR
detector or door contacts is set belong to guard zone 3,when this detector emit signal to
the alarm main set, the main set zone 3 will not report signal out even in guard state,but
other detectors belong to other zones will be working as usual..
*
withdraw guard setting:
When not in alarm state, press four digits user password consecutively (for example:
“1234”, ect),then press key “set” ,then press digit “ 0 ”, the “GUARD” LED on the main set
will go out ,the main set went into status of withdraw guard. At this time if the main set
received the alarm signals from detectors of zone 1,2,3,4,, it will not alarm.
When in alarm state,simply press four digits user password on the keypad will cancel guard
