ANSI ROPE TERMINATION ANCHOR, Руководство пользователя, Страница: 3 / 8

Ÿ
Rope Threading:
Ÿ
Pass the attachment end of the rope through hole1, and pull
the rope through the hole.
Ÿ
Insert the attachment end rope through hole 2 and pull
through without making any slack.
Ÿ
Continue by attachment rope end through hole 3 and pull
through so that there is no slack.
Ÿ
Thread the rope end through hole 4 and pull through so there
is no slack.
Ÿ
Thread rope end through hole 5 & pull through. Leave a 1”
diameter loop of slack.
Ÿ
Now Position the rope end around to back of
and insert through 1” diameter loop.
Ÿ
Firmly pull the rope end until loop tightens to form a knot,
Ensure there is no rope slack over entire length of
.
6. ADVISE & INFORMATION:
Ÿ
It is essential to verify that the medical condition of the user is to use
the connectors in normal & emergency use i.e. user must be
medically t to use the device.
Ÿ
A rescue plan shall be in place to deal with any emergencies that
could arise during work.
Ÿ
It is prohibited to make any alterations or additions to the equipment
without the manufacturer prior written consent, and any repair shall
only be carried out in accordance with manufacturers procedures.
Ÿ
Equipment shall not be used outside its limitation, or for any purpose
other than that for which it is intended.
Ÿ
are personal property of the user.
Ÿ
It is essential for safety that equipment is withdrawn from use immediately if ever subjected to a fall arrest. Do not use again until
conrmed in writing by a competent person that it is acceptable to do so.
Ÿ
Ensure that the strength of the anchorage member used is greater than 5000lbs.(22.2 kN).
7. MATERIAL : Aluminium
8. MAINTENANCE, CLEANING, AND STORAGE :
Ÿ
If the Rope Termination Anchor fails inspection in any way, immediately remove it from service, and contact TheHarnessDepot for
all maintenance and repair needs.
Ÿ
Cleaning after use is important for maintaining the safety and longevity of
Ÿ
Remove all dirt, corrosives, and contaminants from before and after each use.
Ÿ
If cannot be cleaned with plain water, use mild soap and water, then rinse and wipe dry. NEVER clean
with corrosive substances.
Ÿ
When not in use, store equipment where it will not be affected by heat, light, excessive moisture, chemicals, or other degrading
elements.
Rope
Termination Anchor
Rope
Termination Anchor
Rope Termination Anchor
Rope Termination Anchor.
Rope Termination Anchor
Rope Termination Anchor Rope
Termination Anchor
6
5
4
3
2
1
PFAS Attachment
Point
Under
Pull Through loop
and tighten Knot.
Leave 1"
loop.
2