Anritsu Spectrum Master MS2720T, Руководство пользователя, Страница: 989 / 1035

3-5 CW Generator Overview Chapter 3 — T-Series Tracking Generator
3-6 PN: 10580-00339 Rev. C Tracking Generator MG
3-5 CW Generator Overview
These Tracking Generator options include a CW Generator. The CW Signal Generator
provides a continuous wave (CW) signal from the
GENERATOR/RF OUT
port of the
instrument.
The following example displays the generator CW signal on the instrument display.
1. Connect a THROUGH cable between the
RF OUT
and
RF In
connectors as shown in
Figure 3-6
2. Set the
Mode
to
Spectrum Analyzer.
Refer to Chapter 1 for details.
3.
Preset
the instrument
(Shift+1 > Preset
).
4. Set the spectrum analyzer frequency range using the Frequency (
Freq)
menu and
submenus. Refer to the Spectrum Analyzer Measurement Guide (10580-00349) for
additional information.
5. Press the
Shift
key, then the
Measure
(
4
) key. Press the
Generator
key.
6. Press the
Output Power
button and set the output power (at the output connector before
any external attenuation).
Figure 3-6. Through Cable Setup Example
RF IN RF OUT
MS2720T
Spectrum Master
Spectrum
Analyzer
9 kHz-xx GHz
Menu
Menu
Shift
Mode
Esc
9
System
8
File
7
Meas
4
Trace
5
Limit
6
Sweep
3
Cal
2
Preset
1
0
. +/-
Enter Enter
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com