Keypad Hard Keys
This section contains an alphabetical listing of the Site Master front panel keypad controls
along with a brief description of each. More detailed descriptions of the major function
keys follow.
The following keypad hard key functions are printed in
black
on the keypad keys.
0-9
These keys are used to enter numerical data as required to setup or per-
form measurements.
+/–
The plus/minus key is used to enter positive or negative values as required
to setup or perform measurements.
·
The decimal point is used to enter decimal values as required to setup or
perform measurements.
ESCAPE
CLEAR
Exits the present operation or clears the status window. If a parameter is
being edited, pressing this key will clear the value currently being entered
and restore the last valid entry. Pressing this key again will close the pa-
rameter. During normal sweeping, pressing this key will move up one
menu level.
Up/Down
Arrows
Increments or decrements a parameter value. The specific parameter value
affected typically appears in the message area of the LCD.
NOTE: At turn on, before any other keys are pressed, the Up/Down arrow key
may be used to adjust the display contrast. Press
ENTER
to continue normal
operation.
ENTER
Implements the current action or parameter selection.
ON
OFF
Turns the Anritsu Site Master on or off. When turned on, the saved system
state at the last turn-off is restored. If the
ESCAPE/CLEAR
key is held
down while the
ON/OFF
key is pressed, the factory preset state will be
restored.
SYS
Allows selection of the system setup parameters and display language. In
cable and antenna analyzer modes, the choices are
Options
,
Clock
,
Self
Test, Status and Language
. In spectrum analyzer mode, the choices are
Options
,
Clock
,
Self Test, Impedance, Status and Language
.
2-6
Chapter 2 Functions and Operations
