Anritsu Precision AutoCal 36585 Series, Справочное руководство, Страница: 16 / 18

2-4 Measuring Pin Depth Maintenance Instructions
2-6 PN: 10410-00279 Rev. C 36585K/36585V RM
K Connector Measurement
1. On the pin depth gauge, loosen the side lock knob.
2. Remove the female adapter from the gauge body coupling nut.
3. Hold the reference block against the end of the gauge body and turn the gauge outer ring until the pointer
rests on zero.
4. Tighten the side lock knob.
5. To measure female connectors, unscrew the gauge coupling nut and slide it forward.
6. To measure male connectors, leave the gauge coupling attached to the gauge body. Screw the female
adapter to the coupling nut.
V Connector Measurement
1. On the pin depth gauge, loosen the side lock knob.
2. Hold the reference block against the end of the gauge body and turn the gauge outer ring until the pointer
rests on zero.
3. Tighten the side lock knob.
4. To measure V male connectors, screw the female adapter onto the gauge coupling nut.
5. To measure V female connectors, screw the male adapter onto the gauge coupling nut.
6. Tolerance/Gauge Settings
Tolerance/Gauge Settings
Refer to Table 2-2 below. When gaging pin depth, if the test device connector measures out of tolerance in the
“+” region of the gauge, the center pin is too long. Mating under this condition will likely damage the mating
connector.
On the other hand, if the test device connector measures out of tolerance in the “–” region, the center pin is too
short. While this will not cause any damage, it may result in a poor connection and consequent degradation in
performance.
Caution
The mating connectors of various RF components may not be precision types. Consequently, the
center pins of these devices may not have the proper pin depth due to looser tolerances. The pin
depth should be measured to ensure compatibility before attempting to mate it to a connector on
Anritsu test equipment.
Table 2-2. Pin Depth Tolerances and Gauge Settings
Connector Type Pin Depth (Inches) Anritsu Gauge Setting
K Male +0.000
–0.0050
Same as pin depth
K Female
V Male
+0.000
–0.0040
Same as pin depth
V Female