Anritsu Network Master MT9090A Series, Руководство по эксплуатации, Страница: 102 / 200

4-4 MT9090A/MU909011A Network Master User’s Guide
Note
Note
If a screen similar to the ones shown in Figure 4-1,
Figure 4-2 or Figure 4-3 does not appear after powering
up, the unit may have failed. Run the unit through a
power cycle (power down / power up). If the problem
persists, contact the Anritsu Technical Support Center or
your local Arnitsu representative (see “Anritsu
Corporation Contact” on page xix).
Fault Locate Application Setups
The setups for the Fault Locate application are accessed via
the Setup screen, these include:
•
Preferences
•
Parameters
•
Auto Save
To access the Setup screen:
1. With the unit powered up and displaying one of the
following screens: Power Meter Step, Fault Locate
Step (Initial screen or Summary screen only), Trace
View or Initial Connection Check step, press the
Menu/Power key . The General Functions pop-
up menu appears.
2. Highlight Setup and then press the Set key . The
Preferences Setup screen appears (see Figure 4-4 on
page 4-5).
Fault Locate Preferences Setups
The Preferences setups enable/disable specific test functions,
access optional equipment, and select the distance unit.