Anritsu BTS Master, Руководство пользователя

Страница: 47 / 296

Spectrum Analyzer 2-22 Spurious Emissions (Out-of-Band)
Spectrum Analyzer MG PN: 10580-00349 Rev. M 2-35
Spurious Emissions (Out-of-Band) Measurements
Three types of measurements are available once you have created an emission mask. You can
choose to sweep the full mask once or continuously, or sweep an individual mask segment.
You can also select to save or not save the measurement results.
Sweeping All Segments Once
1. Press the
Sweep
submenu key and select
Single
.
2. Press the
Auto Save
submenu key and select
Off
,
On
, or
Full
. Refer to “Auto Save
Modes” .
3. Press
Sweep All
to initiate one measurement sweep of the full spurious emission mask.
See Figure 2-20 .
Sweeping All Segments Continuously
1. Press the
Auto Save
submenu key and select
Off
,
On
, or
Full
. Refer to “Auto Save
Modes” .
2. Press the
Sweep
submenu key and select
Continuous
to start the measurements.
3. Press
Sweep
again to select
Single
and stop the measurements.
Sweeping an Individual Segment
1. Press the
Sweep
submenu key and select
Single
.
2. Press the
Auto Save
key and select
Off
,
On
, or
Full
. Refer to “Auto Save Modes” .
3. Press
Sweep Once
to initiate one measurement sweep of the currently selected
segment, which is highlighted in yellow in the Spurious Emission table. See
Figure 2-20 .
Figure 2-20. Spurious Emission Measurements