Anritsu BERTWave MP2100B, Руководство по эксплуатации, Страница: 79 / 382

2.11 Setting Control Panel
2-25
2
Before Use
2.11.2 Setting Control Panel
The system time, external display settings and touch panel settings are
set at the Windows Control Panel. Do not change any settings other than
those listed in Table 2.11.2-1.
Table 2.11.2-1 Description of Control Panel
Icon Description
Date and Time
 Change the date, time and time zone as necessary.
 Internet Time is set to off at factory shipment. Operation may be affected if this
setting is changed.
Display
Intel® GMA Driver for Mobile
 This setting must be changed when connecting an external monitor to the VGA
connector. For details, refer to Section 2.12 “Using External Monitor” for details.
 Changing the screen resolution, refresh rate or power management, or enabling
the screen saver may cause abnormal BERTWave operation.
Figure 2.11.2-1 shows the initial Display Settings.
Power Options
 The setting of the auto monitor off function (Turn off monitor) can be changed.
 The setting of the power off function for hard disks (Turn off hard disks) is set to
Never by default. Do not change the setting.
 For any other settings in the Power Options Properties dialog box, do not change
from default. Otherwise, the BERTWave cannot operate normally after resuming
from hibernation.
Touch Panel
 This calibrates the touch panel detection point. For details refer to Section 10.6
“Touch Panel Position Calibration”.
Figure 2.11.2-1 Initial Display Settings