Anova RLT12GVH, Инструкции по установке и Руководство пользователя

Страница: 9 / 16

Before performing maintenance, the log splitter must be placed in maintenance
mode.
1.) Shut off the engine.
2.) Move control valve handle back and forth to relieve hydraulic pressure.
After performing maintenance, make sure all guards, shields, and safety features
are put back in place. Failure to heed this warning may result in serious injury.
See engine owner's manual for engine maintenance.
That When How
hoses each use Inspect exposed wire mesh and leaks. Replace all worn or
damaged hoses before starting the engine.
Hydraulic fittings each use Inspect for cracks and leaks. Replace all damaged
connections before starting engine.
Nuts and Bolts each use Check for loose screws
Beam each use Apply grease to the beam surface.
Mobile parts each use clean up debris
CAUTION
Residual Hydraulic Power
The pressurized hydraulic fluid must release residual energy before performing any maintenance or repair work on
the log processor. Hydraulic fluid can be highly pressurized even when the processor motor is off. Escaping
hydraulic fluid under pressure can penetrate skin and cause serious injury.
To release residual hydraulic energy:
1. Turn off the engine
2. Move the control valves back and forth, from one travel limit to another, at least four times.
3. Hold the valve for three seconds at each travel limit.
CAVEAT
Skin injection hazard.
High-pressure fluid can be injected under the skin and cause serious injury,
including amputation.
-Make sure all connections are tight before applying pressure. Relieve system
pressure before performing maintenance.
-Do not check for leaks by hand. Instead, use a piece of cardboard to check for
leaks.
-If an injection occurs in the skin, search immediately.
"surgical treatment"