• Do not drag the assembled unit across any surface.
• This product requires only periodic cleaning with a sponge and a solution of mild detergent and water to
remove surface dirt. Do not clean with a solvent or petroleum based products.
• Furniture must not be used other than for its intended purpose and should be inspected regularly for loose,
missing, or broken hardware, and general instability.
• Furniture that is damaged or appears to be unstable must be removed from service and be repaired or replaced.
• Repairs must be made using only factory authorized parts and methods.
wArnInG
cAre And
mAIntenAnce
211 No
rth Lindbergh Blvd.
St. Louis, MO 63141
tel: 888.535.5005
web:
anovafurnishings.com
11/2012
Seat Support
Phillips Head Screws
Seat Braces
Phillips Head
Screws
Seat End Cap
3.0” Carriage Bolt
Hex Nut
Lock Washer
Flat Washer
3” Long
Carriage Bolt
Nylock Nut
Lock Washer
Flat Washer
Seat Plank
Seat Support
Bench Support
Hex Head Bolt
Flat Washer
Flat Washer
Lock Washer
Hex Nut
Seat End Cap
Bench Support
5. Locate the two Seat Braces and position each one about 2 ft from the ends of the Bench. Use the Driver with Phillips Head Bit to
drive Phillips Head Screws through the Seat Brace mounting holes and into the predrilled pilot holes in the Seat Planks.
NOTE: Do not install Phillips Head Screws into the center Plank until
instructed in Step 7.
6. Locate the Seat Support and position it so that the flange with
the mounting holes align with the mounting holes in the Bench
Support and the pilot holes in the Plank - you may have to switch
the ends of the Seat Support to get all the holes to line up.
7. Place a Flat Washer on one of the Hex Head Bolts and install the Bolt through the mounting holes in one end of the Bench
Support and the Seat Support. Put a Flat Washer, Lock Washer, and Nut on the end and tighten finger tight.
Install the remaining Hex Head Bolt with Flat
Washers, Lock Washer, and Nut through the
mounting holes at the other end of the Bench.
Leave the Hex Head Bolt finger tight to allow for
adjustments.
Use the Driver with Philips Head Bit to install
Phillips Head Screws through the Seat Support,
Backrest Brace, and into the predrilled pilot holes
in the Seat Plank.
8. Place a Flat Washer and Nylock Nut on the end of both 3.0” Carriage Bolts. Tighten all the Carriage Bolt and Hex Head Bolt
hardware sets.
9. Turn the Bench upright and move it to the desired location.
10. Retighten hardware two weeks after initial assembly.
