Do not drag the assembled unit across any surface.
•
This product requires only periodic cleaning with a sponge and a solution of mild detergent and water to
•
remove surface dirt. Do not clean with a solvent or petroleum based products.
Furniture must not be used other than for its intended purpose and should be inspected regularly for loose,
•
missing, or broken hardware, and general instability.
Furniture that is damaged or appears to be unstable must be removed from service and be repaired or replaced.
•
Repairs must be made using only factory authorized parts and methods.
•
wArnInG
cAre And
mAIntenAnce
211 No
rth Lindbergh Blvd.
St. Louis, MO 63141
tel: 888.535.5005
web:
anovafurnishings.com
09/2013
14. Install four Phillips Head Screws through the Angle Support and into the Angle Braces, then install a Phillips Head Screw
through the ends of the Angle Support and into the Leg Mounts.
15. Install the remaining Angle Support on the other side of the Angle Braces in the same manner.
T30 Washer Head Screws
T30 Washer Head Screws
T30 Washer
Head Screws
Angle Brace
Leg Mount
Phillips Head Screws
Phillips Head Screws
16. Carefully turn the Table right side up. Start four T30 x 3.0” Washer Head Screws into the predrilled holes near the ends of each of
the Seat Planks until the points of the screws start to emerge from the other side of the planks. Line up the points of the screws
with the predrilled holes in the Seat Supports and use the Torx T25 Driver to tighten the screws.
Place a T30 x 3.0” Washer Head Screw into the predrilled hole in the center of each Seat Plank and use the Torx T30 Driver to
tighten the screws, making sure the screws are driven into the Seat Stiffener.
Install the remaining Seat
Plank in the same manner.
Move the Table to the
location where it will be
used.