anovafurnishings.com
888.535.5005 tel
Right Leg
Left Leg
Right Leg
Left Leg
Assembly InstructIons
rcp6
Recycled Plastic Picnic Table
tools needed:
Ratchet with 9/16” Socket
•
T25 Torx Driver
•
T30 Torx Driver
•
Phillips Head Driver
•
Hammer
•
16 x
3/8-16 X 3.5”
Carriage Bolt
16 x
3/8” Split
Washer
22 x
Torx T30 X 3.0”
Washer Head Screw
Assembly:
The assembly is a two-person operation.
1. Inspect the shipping container contents for damage and to determine that all components and hardware are present.
2. Assemble the Table over the shipping packaging or padded work area to avoid scratching the product.
Note: Before assembling the Nuts to the Bolts, it is recommended that a light oil or petroleum jelly be applied to the screw threads
tAble components:
2 x Angle
Brace
2 x Seat Plank
2 x Support Bar
2 x Seat Stiffener
20 x
T25 X 2.5”
Torx Head Screw
Right Leg
Left Leg
3 x Table Top Plank
Assembly HArdwAre:
2 x Seat Support
2 x Right Leg
8 x
T25 X 3.0”
Torx Head Screw
2 x Angle
Support
16 x
3/8” Flat
Washer
3. Lay the three Table Top Planks out on the padded work area. The Table Top Planks can be distinguished from the Seat Planks
because the Table Top Planks have four predrilled through holes and four inner pilot holes while the Seat Planks have five
predrilled through holes. Arrange the Table Top planks with the four inner pilot holes facing up.
2 x Left Leg
T25 x 2.5” Torx Screws
Angle Brace
Mounts
Table Top
Planks
4. Locate the two Angle Brace Mounts. Use the T25
Torx Driver to start six T25 x 2.5” Torx Screws
into the predrilled holes in one of the Angle Brace
Mounts. Drive the Screws into the Brace Mount
until the points emerge on the other side. Place
the Angle Brace Mount over one of the inner rows
of predrilled pilot holes in the Table Top Planks,
aligning the points of the Torx Screws with the
pilot holes.
Use the T25 Torx Driver to drive the Screws into
the Table Top Planks until tight.
Repeat this step for the other Angle Brace Mount.
60 x
#10 X 3/4”
Phillips Screw
2 x Leg Mount
2 x Angle
Brace Mount
2 x Leg Mount Brace
16 x
3/8-16
Hex Nut