■
Kickback protector
This saw is also equipped with a chain brake that will stop the chain in the
event of kickback if it works properly. You should check the chain brake
operation before each use, running the saw at full speed for 1 or 2seconds
and pushing the front hand guard forward. The chain should stop
immediately with the engine running at full speed. If the chain stops
slowly or does not stop, contact the maintenance center of the
manufacturer or importer to replace the brake band and clutch drum
before use.
It is extremely important that the chain brake is checked for proper
operation before each use and that the chain is sharpened to
maintain the level of recoil safety of this saw. Removal of safety devices,
improper maintenance, or improper replacement of the bar or chain can
increase the risk of serious personal injury due to kickback.
■
Cutting down a tree
1.
Decide the direction of felling taking into
account the wind, support of the tree, the location
of heavy branches, ease of work after felling, and
other factors.
(A)
Felling cut.
(B)
Notch cuts.
2.
While cleaning the area around the tree, organize a good foothold and
retreat path.
3.
Make a notch one-third of the way in the tree on the felling side.
4.
Make a felling cut from the opposite side of the notch and at a level slightly
higher than the bottom of the notch.
When felling a tree, be sure to warn neighboring workers of the
danger.
■
LOG CUTTING AND SPREADING
1.
Always make sure your footing, as well as the stability of the tree.
2.
Watch for the rolling of a cut log.
3.
Read the “Safe Operation” instructions to avoid kickback from the saw.
Before starting work, check the direction of the bending force inside the log to be
cut.
Always finish cutting from the opposite side of the folding direction to prevent the
guide bar from getting caught in the cut.
Cutting an unsupported log
Saw half way, then roll the log and cut from the
opposite side.
Содержание MG246
Страница 30: ...16 PARTS...
