2 of 4
Locate the Lower Leg Bracket. Install a 5/16”
4.
Flat Washer on one of the 5/16” Hex Head
Bolts and insert the Bolt through one of the
mounting holes in the Lower Leg Bracket
and into the lower mounting hole in one of
the Seat Supports. Place a 5/16” Flat Washer
and Flanged Nut on the end of the Bolt and
tighten finger tight.
Table Top Pan
5/16” Hex Head Bolt
Seat Support
5/16” Flat Washer
Seat Support
Flanged Nut
5/16” Flat Washer
Seat Support
Lower Leg Bracket
5/16” Bolt
5/16” Flat Washer
Flanged Nut
5/16” Flat Washer
Packing cardboard or
other soft work surface
Repeat Step 4 for the remaining
5.
Seat Supports using 5/16” Bolts with a
5/16” Flat Washer on the top and bottom and
Flanged Nuts to secure. Leave the hardware
finger tight until after the Table Top Pan is
secured (Step 7).
Locate the Table Top Pan and place it on top of the platform created by the raised ends of the Seat Supports. Adjust the
6.
placement of the Table Top Pan until one set of mounting holes in the Pan align with the corresponding set of mounting holes
in one of the Seat Supports.
Place a 5/16” Flat Washer on the end of one of the 5/16” Hex Head Bolts and insert the Bolt through the Pan mounting hole in
the inner bolt circle and through hole in the Support. Fasten the Bolt using a 5/16” Flat Washer and Flanged Nut on the bottom
of the Bolt. Leave the Bolt and Nut finger tight. Repeat this for the remaining four 5/16” Hex Head Bolts. You may have to
adjust the Seat Supports or the Table Top Pan in order to get the mounting holes to align.
