Anolis ArcPower 48 Outdoor, Руководство пользователя, Страница: 20 / 25

ArcPower 48 Outdoor
20
6.7 Special functions
rdM Low --- RDM Code .This menu item shows the first part of the RDM identification code.
rdM High --- RDM Code . This menu item shows the second part of the RDM identification code.
LED type --- LED colour variant . This menu allows to set desired colour variant according to connected
LED module.
RGBW –
RGBW variant.
Sin. Col. –
Single colour variant.
Smart W. –
Smart white variant.
RGBA –
RGBAmber variant.
Note: The menu items and DMX chart will be changed according to set colour variant!
Wireless --- Wireless state .
This menu serves for reading of the state of wireless operation (only Wireless DMX).
Unlink -
The item serves for unlinking the fixture from the transmitter (only Wireless DMX version)
IniBlink --- Initial blink. If this function is on, the fixture makes auto-calibration (each LED colour lits on 100% for
short time) after switching the fixture on.
HoLd DMX --- If the function is on, the last received DMX values are held in case, that DMX data receiving was
interrupted (e.g. disconnected DMX controller).
Flicker Free M ---F licker free mode. If the function is on, the light flickering visible in cameras is corrected but
colour uniformity is worse.
Adjust - Adjustment . The menu allows the fine adjustment of colours.
DMX Val - DMX values . Use the menu to set DMX values of fixture´s channels.
Cal Col - A calibration o red, green, blue and white colours by means of an automatic calibration
with a factory equipment.
Red C – red LEDs saturation (0-255)
Grn C – green LEDs saturation (0-255)
Blu C – blue LEDs saturation (0-255)
Whi C – white LEDs saturation (0-255)
Cal Temp – Selection of colour temperature for manual calibration: 2700K, 3200K, 4200K, 5600K,
8000K.
Manual colour calibration:
1. Connect the fixture to the mains , go to the “Manual” menu and set the shutter,dimmer, red, green, blue
and white channel at 255DMX and let the LED module heat up (cca 1 hour).
2. Go to the “Manual” menu and set the C Wheel at 1 DMX (2700K)
3. Go to the “CalCol” menu, select “2700K” item and by means of the Red C, Green C, Blue C and White C
items adjust the 2700K colour temperature as exactly as possible (∆u´v´= 0).
After calibration, press the “Store“ item to save adjusted values.
4. Go to the “Manual” menu and set the C Wheel at 4 DMX (3200K).
5. Go to the “CalCol” menu, select “3200K” item and by means of the Red C, Green C, Blue C and White C
items adjust the 3200K colour temperature as exactly as possible (∆u´v´= 0).
After calibration, press the “Store“ item to save adjusted values.
6. Repeat this procedure for rest of colour temperatures (4200K, 5600K,8000K).