Anolis ArcPower 36, Руководство пользователя

Страница: 11 / 19

10 11
8.Control board
The control panel situated on the top cover of the ArcPower 36 allows DMX addressing,calling build-in programs
and setting the fixture behaviour
Control elements:
[ENTER] button- enters menu,confirms adjusted values and leaves menu.
, [UP] button and[DOWN] button- moves between menu items on the the same level, sets values.
In order to leave the menu without saving value,press [UP] and [DOWN ] at the same time.
After switching on the ArcPower 36 ,the display shows the initial DMX address:
Use [UP],[DOWN] to browse through the menu. To select a function or submenu,press [ENTER].
8.1 Addressing the ArcPower 36
The fixture can be uperatated in the two modes: DMX mode -fixture is controlled via DMX 512 by an external
DMX controller
Stand-alone mode - fixture uses build-in programs and is
able to control other fixtures in the master/slave chain.
See the chapter "Stand-alone mode" for detail description.
For DMX mode is important the DMX start address that is defined as the first channel from which the ArcPower
36 will respond to the DMX controller.
Setting the DMX start channel for DMX operating:
1. Connect ArcPower 36 to the mains.
2. Browse through the menu by pressing the [UP] and [DOWN] buttons until the display shows current addres
"001" .Confirm by pressing [ENTER] button and "001" will start to flash frequently.
3. Use the [UP] and [Down] buttons to select the desired address.
4. Confirm by pressing [ENTER].
After having addressed ArcPower 36 , you may now start operating ArcPower 36 via your DMX controller.
8.2 Program running
By enter to this menu a complete overview of all programs is offered,from which the program to be run can
be selected by pressing [ENTER].Selected program runs in a loop.The fixture includes 10 built-in programs
(P.01-P.10) and 3 free editable programs (E.P.1-E.P.3),each up to 50 steps.
If Item "
AUt
" is On,the fixture in DMX mode will remember last running program and this program will run after
switching on the fixture.
Each program step has a fade time-the time during which effects go to the current step and a Standing time-
-the time,during which effects last in the current step.
Programming procedure: