anko MT-600, Инструкция по эксплуатации

Страница: 25 / 36

Page 25 of 36
13.3 Cleaning Robot Body and Accessories.
Do Not
clean the Robot, components or accessories with petrol, solvents,
any other flammable liquids, harsh abrasives, etc.
Clean only the outside of the Robot and in the dust canister compartment.
Use only a damp cloth and mild detergent for cleaning the Robot,
components and accessories.
After cleaning, wipe any moisture off the Robot, components and
accessories with a dry cloth.
Do Not place accessories and components in a dishwasher.
13.4 Cleaning / Replacing the Robot Spinning Brushes.
Before each use, check the brushes for damage, wear and tear, or whether
they have foreign objects stuck in them.
The side brushes should only be replaced if they are damaged
Ensure the Robot is switched off. The switch on the side of the Robot must
be in the “O” Off Position.
• Remove the Dust Canister.
•
Turn the Robot upside down
to access the brushes.
•
Visually inspect the brushes
and if tangled with hair, thread
or any other foreign objects,
remove them before using.
•
To remove, grasp the brush firmly and pull straight up until it releases
and lifts away.
•
Refit new side brushes.
Spare Brushes can be purchased from our Customer Service.