5
re-boil the water again
,
wait for 30 seconds. This will allow the thermostat to reset, before
pressing the power switch again to re-boil the water. You may shut OFF power to the kettle
by just lifting the kettle from the power base at any time to stop the boiling process.
NOTE
: Ensure that switch is free of obstructions and the lid is firmly closed. The kettle will
not turn OFF if the switch is constrained or if the lid is opened.
5. Lift the kettle from the power base and then pour the water carefully.
NOTE
: Proceed with caution when pouring the water from your kettle as boiling water may
result in scalding. It is important not to open the lid while the water in the kettle is hot.
6. The kettle will not re-boil until the switch is pressed again. The kettle may be stored on
the power base when not in use.
NOTE:
Always disconnect from mains power outlet socket when not in use.
BOIL-DRY PROTECTION
Should you accidentally let the kettle operate without water, the boil-dry protection circuit
will automatically switch OFF power to the kettle. If this occurs, allow the kettle to cool
down for few minutes prior to filling with cold water.
CLEANING AND MAINTENANCE
Always disconnect the appliance from the mains power outlet and allow it to cool down
completely before cleaning.
1. Never immerse the kettle body, power cord or power base in water, or allow moisture to
come in contact with these parts.
2. Wipe the kettle body with a damp cloth, never use abrasive cleaners.
CAUTION
: Do not use chemical, steel, wooden or abrasive cleaners to clean the outside of
the kettle to prevent damage to the glossy surface.
3. When not in use or during storage, the power cord should be wound under the power base.
REMOVAL OF MINERAL DEPOSITS
Your kettle should be periodically descaled as the mineral deposits in tap water may form
scale on the bottom of kettle and this may cause it to operate less efficiently. You can use
commercially available descaling solution by following the instructions supplied with the
