PAGE 3
Check the tool before use
Due to modern mass production methods, the likelihood that your drill is faulty
or missing standard parts is unlikely. If any parts are missing or you detect a
fault of any kind, do not use the tool until parts have been replaced and/or the
fault has been rectified. Failure to do so may result in serious personal injury.
Caution:
Do not use the charger if the power cord is damaged. It must be replaced
immediately by an authorised service professional.
Specifications
Charging adaptor
Voltage.....................................................
10
0-240V~50
/60
Hz
Output......................................................15V
Current.....................................................400mA
Cordless drill
Power rating ……………...…………..…..12V
No load speed ………..…………………. 0-
700
/min
Chuck capacity ………......………..……..10mm
Drilling capacity wood …….…..…….......10mm
Sound pressure level…..……………........ 64
.7
dB
(A) K=3dB(A)
Sound power level………..……….…....... 75
.7
dB
(A) K=3dB(A)
Vibration level……………………………....
1.464
m/s2
K=1.5m/s2
The sound intensity level for the operator may exceed 85dB(A) and sound
protection measures are necessary.
Note:
-ÿThe declared vibration total value has been measured in accordance with a standard test
method
and may be used for comparing one tool with another.
Standards list as:
AS/NZS 60745.1
AS/NZS 60745.2.1
AS/NZS 60745.2.2
-ÿThe declared vibration total value may also be used in a preliminary assessment of exposure.ÿÿ
W arning:
-ÿThe vibration emission during actual use of the power tool can differ from the declared total
value
depending on the ways in which the tool is used.
-ÿVibration emitted by the tool can cause anesthesia of your hand and arm, if you have worked
with
it for a long time. Some countermeasures against the vibration are listed below.
