4. Timer setting:
A switch ON time or a switch OFF time can be set from 0:30h - 23:30h.
4.1 Under ON mode, set one your desired function (e.g. Low Heat Output/ High Heat
Output/ Auto Mode/ Frost Protection Mode), then press
button to enter into TURN ON
timer setting. The icon
& will light on. Press buttons "
" "
" to select the desired
range between 00:30 to 23:30 hours. The timer will increase or decrease by 0.5 hour after
each press. In the timer setting, the timer symbol
will light on and be shown on the
display. The setting will be memorized and confirmed after 3 seconds.
For example, if you set the timer to 1 hour, the heater will switch ON automatically after 1
hour.
Note: You can cancel the TURN ON timer by pressing on/off button
or by changing the
current function setting.
4.2. Under ON mode, press
button to enter into TURN OFF timer setting. The icon
&
will light on. Press buttons "
" "
" to select the desired range between
00:30 to 23:30 hours. The timer will increase or decrease by 0.5 hour after each press. In the
timer setting, the timer symbol
will light on and show on the display. The setting will be
memorized and confirmed after 3 seconds.
For example, if you set the timer to 1 hour, the heater will switch OFF automatically after 1
hour.
Note: You can cancel the TURN OFF timer by pressing on/off button
or by changing the
current function setting.
5. Child Lock
Press the
“+”
and
“
-
“
button simultaneously for 5 seconds to activate the child lock function
for
ON
or
OFF.
The symbol "
" will light up or go out on the LED display.
Settings can be adjusted again after turning off the child lock function.
Note: This function can only be set from the heater, and not by remote control.
OPERATING SOUND
The appliance emits a beep upon each operation setting.
NOTE:
There is a tip-over switch inside the heater. If the heater is knocked over, the power
to the heater will shut off automatically.
WARNING! FOR ELECTRICAL SAFETY THIS APPLIANCE MUST BE PLUGGED INTO
AN EARTHED ELECTRICAL POWER SOCKET OUTLET!
–
If you are uncertain,
please consult an electrician.
