OPERATION
The Hot Hair Brush combines the benefits of a hairdryer with a round brush in one
appliance.
2 barrels available which suitable to use on all hair lengths, the 50m brush for medium
to long hair and 40mm brush for shorter styles.
To use the Hair Brush, fully unwind the mains cable. Make sure the Heat Setting Switch
is in OFF (0) position.
Place the appliance on a smooth, flat, dry surface, plug-in and switch on at the mains
supply.
Use the high heat setting for initial drying, and the low heat setting as the hair begins to
dry and for styling.
Use the cool setting to set the style for longer lasting results after drying and styling.
Position 0 – OFF
Position C – Cool air
Position 1 – Low heat setting
Position 2 – High heat setting
For styling hair, make sure your hair is 80% dry. Take a section no more than 4 to 5 cm
wide. Place the appliance into the hair, close to the roots.
Move the brush through the hair towards the ends. When reach the end of the section,
start to rotate the brush by pressing and holding the rotation button (C).
There are two rotation buttons marked
and
, these will make the brush head
rotate clockwise and anticlockwise.
As you do this, resist the rotation of the brush by pulling the brush downwards. This will
create tension through the section of hair which will add the root lift.
For even more volume, wind the entire section of the hair around the barrel until you
reach the root. Release the rotation button and then leave the brush in the hair for a
few seconds.
Slide the switch to cool air setting for a further few seconds to create long, lasting
volume.
NOTE:
When the appliance is used on the cool air setting, the brush head will not rotate.
Unwind the section by pressing and holding the opposite rotation button.
When finished drying or styling, switch the appliance OFF, unplug the appliance and
allow it to cool before putting it down/ storing.
IMPORTANT! Place protective cover over brush head after use to avoid accidental burn.
BRUSH BARREL
Make sure the hot air styler is disconnected from the mains power outlet socket.