anko ADW6012W, Инструкция по эксплуатации

Страница: 7 / 28

7
Installation Instructions
WARNING!
Electrical Shock Hazard
Disconnect electrical power before installing dishwasher. Failure to do so could result in death or
electrical shock
ATTENTION! The installation of the pipes and electrical equipments should be done by professionals.
Power Connection
WARNING!
For personal safety:
Do not use an extension cord or an adapter plug with this appliance.
Do not, under any circumstances, cut or remove the earthing connection from the power cord.
Electrical requirements
Please look at the rating label to know the rating voltage and connect the dishwasher to the appropriate
power supply. Use the required fuse 10A, time delay fuse or circuit breaker recommended and provide
separate circuit serving only this appliance.
Electrical connection
Ensure the voltage and frequency of the power being corresponds to those on the rating plate. Only
insert the plug into an electrical socket which is earthed properly. If the electrical socket to which the
appliance must be connected is not appropriate for the plug, replace the socket, rather than using an
adapter or similar as they could cause overheating and burns.
Ensure that proper earthing exists before use.
Positioning the appliance
Position the appliance in the desired location. The back should
rest against the wall behind it, and the sides, along the adjacent
cabinets or walls. The dishwasher is equipped with water supply
and drain hoses that can be positioned either to the right or the
left sides to facilitate proper installation.
Leveling the appliance
Once the appliance is positioned for leveling, the height of the
dishwasher may be altered via adjustment of the screwing level
of the feet. In any case,the appliance should not be inclined
more than 2°.
Cold water connection
Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure that it is fastened
tightly in place. If the water pipes are new or have not been used for an extended period of time, let the
water run to make sure that the water is clear. This precaution is needed to avoid the risk of the water
inlet to be blocked and damage the appliance.
8
Water Supply And Drain
Cold water connection
Connect the cold water supply hose to a threaded 3/4(inch)
connector and make sure that it is fastened tightly in place.
If the water pipes are new or have not been used for an
extended period of time, let the water run to make sure that
the water is clear. This precaution is needed to avoid the risk of
the water inlet to be blocked and damage the appliance.
Please close the hydrant after using.
NOTE
:
Position The Appliance
Position the appliance in the desired location. The back should rest against the wall
behind it, and the sides, along the adjacent cabinets or walls. The dishwasher is
equipped with water supply and drain hoses that can be positioned either to the right
or the left sides to facilitate proper installation.
Levelling the appliance
Once the appliance is positioned for levelling,
the height of the dishwasher may be altered via
adjustment of the screwing level of the feet.
In any case,the appliance should not be inclined
more than 2
°
.
NOTE
:
Only apply to the free standing dishwasher.