7.1.1 Removal of coffee fur
A sachet of coffee fur remover solvent is
supplied with the machine. Usage is
extremely simple.
1.
Take a bowl filled with ca. 5 litres warm
water and dissolve the coffee fur remover
solvent from the sachet into it.
2.
Put the parts that need to be cleaned in the
bowl and soak them for 15 to 30 minutes.
3.
Rinse several times with warm water. Repeat
treatment if the result is insufficient.
4.
Scatter coffee fur remover solvent on very
filthy spots and clean with a wet brush.
7.2 Descaling
1.
Switch off the machine (fig. 2B & 3B).
2.
Slide the basket filter into the machine and
place an empty jug on the lower hot plate.
3.
Dissolve 1 sachet of 50 grams of Animo
descaling agent in 1 litre of lukewarm 60 -
70˚C water (see instructions for use on the
labelling).
A 100 (manual filling)
4a
Pour 1 litre of Animo descaling agent into
the reservoir (fig. 1F) and switch on the
machine (fig. 2B). The solution will now
begin to flow through the system.
4b
Leave the reservoir lid open!
A 200 (automatic filling)
4a.
Pour 1 litre of Animo descaling agent into
the reservoir (fig. 1F) and switch on the
machine (fig. 3B).
4b.
Turn the selection switch (fig. 3C) to the
half position and press the start button
(fig. 3D). The solution will now begin to
flow through the system.
4c.
Leave the reservoir lid open!
*
Attention! If the machine begins to steam
heavily, switch it off immediately (fig. 2B
& 3B). Wait for 1 minute. The solution will
flow through automatically. Switch the
machine back on. Press the start button
(fig. 2D) as well (A 200 only).
5.
When half of the solution has run through
the machine, switch it off for about 2
minutes (fig. 2B & 3B). The solution will
now undergo a reaction with the lime scale.
6.
After the pause, switch the machine back
on and allow the rest of the solution to
flow through the machine. Press the start
button again (fig. 3D) (A 200 only).
*
Attention! Keep an eye on the reservoir
while the solution is running through the
machine. Turn the machine off as soon as
the reservoir is empty. Then rinse clean the
metal contacts in the cold water reservoir
with water or a wet cloth.
7.
After descaling the machine, rinse
thoroughly by carrying out the normal
coffee preparation process 3 times (without
paper filters and coffee).
8.
Clean the basket filter and jug thoroughly.
9.
The machine is now ready to be used again.
8. TRANSPORT
The following procedure should be followed when
the appliance is transported:
1.
Switch off the machine (fig.2B & 3B) and
remove the plug from the wall socket.
2.
Close the water supply tap and disconnect
the supply hose.
3.
Remove the jugs and the basket filter.
4.
Empty the machine, by turning it upside
down above the sink, so that the remaining
water runs out through the spray head
(attention: the water can still be hot!)
5.
Wipe the machine dry, and replace all the
components that have been removed.
6.
The machine is now ready for transport.
7.
When it is relocated, the procedures of
“Installation”, should be followed.
Animo
A 100 /A 200
10/99
6
