Angst+Pfister PO2ES-103P, Руководство пользователя

Страница: 1 / 2

Connect Interface PO2ES-103P Sensor 0...25 %VolO
2
and 0…100 %VolO
2
Measurement range: 0…25 %VolO
2
or 0…100 %VolO
2
Supply voltage: 18-36V DC
Analog output signal: 4-20mA (max. Shunt: 10 Ohm @ 18V; ~500 Ohm @ 36V)

Measurement of sensor voltage (0…50 mV) with 15 bit resolution

If the LED light flickers, the sensor voltage is outside of the measurement range

Manuel calibration via button (jumper setting "Hand")
:
a. Press the button HANDKAL for minimum 5 seconds => LED flashes
b. After 1 minute of stabilization time the sensor voltage are set to be equal to
20,95 %VolO2

Auto­calibration (jumper setting "Auto"):
a. The sensor voltage is measured continuously over a time period of 7 days, and the maximum
sensor voltage are stored. The stored value is after 7 days set to be equal to 20,95 %VolO
2
,
after which a new 7 day period start. In this way sensor drift is corrected.
c
. A manual correction of the output signal can be made using the Potentiometer (
"
Verst.
"
).
It is possible to adjust the output /- ~2 mA @ 20 mA.
At
"
Messpunkt (MP)
"
the output signal in voltage (0,4 Vto 2,0 V) can be measured.
1 PO2ES-103CI_1620-21573-0001-E-0321