E
N
7
PAUSING AND
RESTARTING THE
SENSOR PAD
• Allows you to pause the
Sensor Pad if you remove
baby from the cot, e.g.
for feeding or comforting.
Ensure to un-pause the
Sensor Pad before putting
baby in the cot
OK
NURSERY UNIT
PRESS
PRESS &
HOLD
PARENT UNIT
Note:
• Your Nursery Unit and Parent Unit come pre-paired
• Each time you power ON your Nursery Unit, the internal thermometer will need to calibrate to ensure
accuracy. This automatic process will take approximately 30 minutes
• The screen of the Parent Unit will flash the out-of-range icon until it displays the room temperature
and function icons. The connection process should be done within 30 seconds. If this sequence is
not completed within 30 seconds you will need to switch the units off and start again
• If you turn the Nursery Unit OFF the Out-of-Range Alarm will sound. Turn the Nursery Unit ON again to
re-establish the link
TEST THE SENSOR PAD
1. Sources of vibration & movement other than your baby’s can be detected by the Sensor Pad
and interfere with the performance of your Angelcare monitor. The
alarm will not sound if it detects movement other than your baby’s
2. There are 3 sensitivity settings – low, medium and high. The unit is set
at medium (default) and can be adjusted accordingly
3. The Sensor Pad will detect false movements if you are touching the cot
4. The monitor will produce a Rouse alarm single beep tone designed to
stir baby if no movement has been detected for 15 seconds. If no further
movement is detected, the main alarm will sound at 20 seconds – a series of continuous beeps
SENSOR PAD FOUR CORNER TEST
1. Place the Sensor Pad at the approximate centre of baby’s sleeping area and put the mattress
back in place
2. Switch ON both Nursery & Parent Units – check both units are paired (connected)
3. Immediately pat your hand lightly and continuously on a corner of the mattress twice for Sensor
to detect movement. If movement is detected you will hear a TIC sound every 5 seconds
4. Step away from the cot
5. The alarm will sound from the Nursery and Parent Unit after 20 seconds. If the
Alarm does not sound, ensure everything is setup correctly and try again;
check battery levels on all units, follow the manual for ‘NO ALARMS’ – the sensitivity
setting may require lowering by a single level due to other vibrations/movements.
6. If the alarm sounds, pat your hand lightly on a corner of mattress twice
for Sensor to detect movement. It may take up to 8 seconds to recognise
movement and for alarm to stop.
7. If the alarm continues, even after lightly patting the corner of your mattress twice, adjust the
sensitivity higher and repeat this test
2
CFO3B_ANGE_Manuel_AC127_ROW.indd 7
19-02-05 08:54
