Anets SLG100, Инструкция по установке и эксплуатации

Страница: 11 / 20

SLG I&O Series
11
4.2 Filling the tank with solid shortening/oil
To fill the tank with solid shortening/oil refer to the following procedure.
Warning
NEVER melt blocks of solid shortening/oil on top of the burner tubes. This will cause a fire
and could result in personal injury.
a. Remove the screen covering the tubes (tube screen).
b.
Cut the solid shortening/oil into cubes no larger than one inch (2.54
cm). ALWAYS pack the shortening/oil below, between, and on top of
the burner tubes.
DO NOT
leave any large air gaps. Use care when
packing the solid shortening/oil into the tank.
DO NOT
bend or break the temperature or high limit sensor probes. If
these are damaged the appliance will not function properly.
c. Once the appliance tank is firmly packed with shortening/oil, the
shortening/oil must be melted. Melt the shortening/oil by cycling the
main burners on for 4 seconds and off for 30 seconds repeatedly,
using the thermostat knob.
5 Operating Instructions
To ensure the quality of the food you cook in this appliance, follow the preparation instructions from the
food manufacturer. Using the best shortening/oil makes the best fried foods. The best shortening/oil will
last longer than lower grade shortening/oil and save you money. When not in use, the shortening/oil
should be cooled and covered to prevent contamination.
Warning
This appliance must be installed using restraining devices to prevent accidental tipping or
movement. DO NOT attempt to move the appliance when it is in use or has hot liquid in it.
Splashing hot liquids can cause severe burns.
Warning
Water and shortening/oil DO NOT mix. Keep liquids away from hot shortening/oil.
Dropping liquid frozen foods into the hot shortening/oil will cause violent boiling.
5.1 Appliance Start-Up
Warning
DO NOT start the appliance without filling the tank with shortening/oil first!
To start up the appliance refer to the following instructions.
a.
Light the pilot as previously described in this manual
b.
Turn the temperature control knob (thermostat) to the desired temperature setting. This
knob is located behind the front doors or on the front control panel.
c. The main burners will light and raise the shortening/oil temperature to the desired setting.